This week we had some interesting projects but also we had a bench tester (Alex) that surprisingly is from Taiwan, maybe he will continue the Taiwanese legacy here in the school in the next group, then it would be 3 groups in a row with someone from Taiwan.
The work we did this week will be better shown in pictures...
 |
| Alex the next Taiwanese legacy (Hopefully) |
 |
| Stan copying a minute jumper in the profile projector which he needs to remake |
 |
| Here's his drawing of the minuet jumper |
 |
| Here we have a tiny little hair that was messing up the timing in the dial down position but no other positions, so if your timing doesn't make any sense make sure you check your incabloc! |
 |
| Stan's bridal rivet that he did this week |
 |
| Yiting was cutting a wheel for her school watch. |
 |
| Let's make sure that you will get the same position back! |
 |
| This is an old cannon pinion (lower one) that Yiting used as a reference, she made a smaller one from the older one that fitted better in her school watch. |
 |
| Here she is finding the center distance of the cannon pinion and the wheel that she was cutting before. |
 |
| Yiting at her work. |
 |
| CJ making some magic for the school watch. |
 |
| Sif is making some levers to be able to lift the hairspring collet higher up on the balance staff to fit it better under the bridge. |
No comments:
Post a Comment